Manual for Concrete Acrylic Stains PDF Print E-mail






Eco-Nova Co.,Ltd.
90 Ladprowb115, Ladprow Rd.
Klongchan, Bangkapi, Bangkok 10240
Tel. 02-3742175 Fax.02-374-2938
E-mail. This e-mail address is being protected from spambots. You need JavaScript enabled to view it .





Allow concrete surfaces to dry before applying stain. When working with more than one container of the same product, intermix to ensure color uniformity. Stir stain before and occasionally during application. Use product when temperature is between 50F to 80F. Use caution when applying the transparent penetrating stain to a very hot surface.

Premature drying of the stain prevents optimum penetration and the development of its transparent character. Lightly dampen very hot surfaces to cool the down before applying stain. (Do not puddle or flood water on to the surface).

Apply the Stain with a conventional garden sprayer, using a push broom to be stained. To achieve a beautiful multi- hue appearance, use multiple coats of the stain/ mixture thinned as desired with water (from 1 quart of water to 1 gallon of stain or up to 2 gallons of water to 1 gallon of stain).

Variations of stain concentration and multiple coats of the stain mixture will produce attractive shading and interesting ranges of color intensities. For very dark, deep accents, use the stain full strength. Stain must be sealed with an approved Triple-S specialty coating sealer. Allow product to dry 24 hours before sealing.




Apply at a spread rate of 200-400 square feet per gallon. If the concrete is broken into sections, apply stain in sections for ease of application.




Attempting to apply the first coat with a brush or roller may result in lap marks. Horizontal surfaces may be subject to premature wear, there fore periodic touch-ups may be necessary. Retain any left over stain for this purpose.


Keep away from heat, sparks and open flames. (Do not smoke in area where UT 70/30 is in use) Avoid Breathing in vapors. Avoid contact with eyes and skin. May cause injury of skin following prolonged or repeated contact. Absorption throughskin may be harmful.



Keep closure tight and container upright to prevent leakage when not in use.

Do not transfer contents to bottles or other unlabeled containers.

In case of fire, use foam, dry chemical or CO2.

Flush area with water spray.

Clean hands thoroughly after use and before smoking or eating.


First Aid:



If swallowed, do not induce vomiting. Call Physician immediately.



Immediately flush with plenty of water for 15 minutes forcibly holding eyelids open. Call a Physician immediately.



Wipe off skin with thinner then immediately wash thoroughly with soap and water. Remove contaminated clothing.


V.O.C does not exceed 120 G.P.L


Dispose of container in accordance with Local and State Regulations.